Caledonia Yawl Project: Installing the knees to the thwart

My next step for the forward compartment was to glue in the perimeter batten to hold the edges of the deck. I used small ribbed copper nails to hold down the battens in place while the epoxy set.

20181007_183828

I will leave the copper nails in as they won’t rust and won’t do any harm.

Then on to the knees that I had laminated a while ago, while I was in a laminating mode with the stems. I had enough off cuts of fir laminating stock to do the knees at that time. But since I’d just run the through the thickness planer when I had rented one for another task.

20181013_184935

The knees were first smoothed with the 1/4 round over bit of the router. That all worked mostly well except on one outer corner of the curve where the wood likely under tension ripped out with the router. I had to then glue the ripped section back down and sand it smooth.  To fit the knees instead of doing a template, I first cut the base angle and then scribed the right angles cuts to fit it to the inner gunwhale. When I made that cut I was a little conservative and I had the plane it down a few times to get it to fit snugly. I then used one side as the template for the other side and it went much faster.

20181013_192835

I’m now just going to do a touch more sanding before I get on to coating it all with Decks Olje. A two part oil finish that creates an fairly easy to refinish gloss coating. I like the rich clear finish it gives. Since I’m not planning on having too much material with a clear finish (Gunwhale, knees, thwart, Centreboard caps and bulkhead trim) I’m not too fussed about the cost. (nearly one third more than the cost of Cetol Natural Teak finish or most varnishes).  I have hesitated with my final choice for a while but ultimately decided to give Decks Olje a shot because of the penetrating oil of part 1 and the ease of touching up. In theory if you keep on top of it you could just touch up abrasions indefinitely without having to strip it all down as you would with varnish. Time will tell if I’m happy with it.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.