Caledonia yawl project: Ripping Jig and other preparations for the stem and apron

To be able to get the 2″x 1/8″ thin strips needed to laminate the apron and stem I need nice clear (knot free) vertical grain wood. In my case that will be Douglas fir.

Last weekend I was able to find several 2×3 lengths that if ripped on its edge will give me 2.5″ wide strips that will give me the margin to plane down to the 2″ width specified. To do this you need to rip accurately, and the solution I found is to make a little jig that attaches to the table saw that should help yield consistent strips throughout the 8″ lenth. After each cut you move the fence over until the board stock rests against the jig guide wheel & repeat.

ripping jig
simple ripping jig with roller

I also went back to the lumberyard to get western red cedar to build up my centerboard and rudder. I’m doing this while the strongback is free of the boat and I have a nice flat surface. That way I’ll get all my laminations done at the same time.

I’ve borrowed from the Gougeon Brothers and tu Gurit Embh. publications on wood foil construction.  Ian Oughtred’s plans and instructions in “Clinker Plywood Boatbuilding Manual” are good but basic and as water is so dense small improvements in execution should have dramatic impacts in performance.

lamination plan for rudder and centerboars
Centerboard stringer design in “How to build rudder blades & centerboards” by J.R. Watson
Gurit instructions for cutting a Naca profile for a centerboard

Gurit’s guide also suggests that in testing stiffness western red cedar sheathed with three layers of unidirectional carbon fiber had a 67% gain in stiffness over just using mahogany.

Leave a Reply